Various Small Knowledge Of Stainless Steel Wire

    Stainless steel wire also known as stainless steel wire, stainless steel for raw materials produced by various specifications and models of silk products, the origin of the United States, the Netherlands, Japan, the cross-section is generally circular or flat shape. Common corrosion-resistant, cost-effective stainless steel wire is 304 and 316 of stainless steel wire.Stainless Steel Wire

The stainless steel wire drawing pulls The wire rod or the line billet from the die hole of the drawing die to produce the metal plastic processing process of the small section steel wire or the non-ferrous metal line under the action of pulling force. Metal and alloy of different cross-section shape and size of wire can be drawn by drawing production. Pull-out wire, precise size, smooth surface, and the use of drawing equipment and die simple, easy to manufacture.

In the drawing process, the transverse section of the wire is increased, and the cross-sectional area and length of the front and back of the drawing are respectively F. , F and L. and L. During the drawing process, drawing stress Sian is used to draw the drawing force on the cross area of the drawing wire at the outlet of the die. In order to deform the metal in the mold hole, the tensile stress Sian must be greater than the deformation resistance Shante of the metal in the deformation zone of the mold hole; In order to prevent the metal wire from forming after the deformation is drawn or pulled down to break the stable drawing process, drawing stress Sian must be less than the yield of the drawing wire after the Shans, so the conditions for the implementation of the drawing process is usually expressed as: S. Call the ratio of K to the safety factor of the pull-out process.Stainless Steel Wire

The Lenglaber metal has undergone obvious deformation hardening, its yield limit Shans value is close to its strength limit Bib, the Bib value in production is substituted for Shans, so the condition of the drawing process can also be expressed as S; the safety factor K of the drawing process is also expressed as the ratio of Bib to Sian.Stainless Steel Wire