Stainless Steel Link Chain According To The Material Classification

    The stainless steel chain as a common transmission power device, through the hyperbolic arc of the "chain" design, reduce the friction, so that the power ratio of the larger and slower operation of the place, than the belt drive has obvious advantages, such as tanks, pneumatic compressors, etc., but the transmission speed can not be too fast, because the chain flexibility is not as good as belt conveyor.Stainless Steel Link Chain

Sort by material

1, the use of high-quality stainless steel manufacturing, with acid, alkali-resistant, cold, long life and other characteristics, widely used in food, chemical, pharmaceutical, rubber, printing, suppression wire and other machinery, and for a variety of import and export machinery supporting, is a modern equipment excellent equipment.

2, stainless steel chain series, such as 304 and 316 and 316L materials with excellent corrosion resistance, such as acid, alkali and -40 high and low temperature occasions. In comparison, 316L has a better resistance to magnetism, rigorous temperature adaptability and chemical corrosion resistance.Stainless Steel Link Chain

3, stainless steel chain series, such as 2cr13, not only have the appropriate anti-corrosion capacity, but also with the same carbon content of carbon steel strength.

The stainless steel chain tells you to check if there is abrasive in the lubricant. Stainless steel chain for better help to understand and apply to the non-standard chain sprocket, stainless steel chain manufacturers focus on the introduction of the chain in the application of the failure of the two forms, I hope that through our explanation can be better to help everyone understand, let's take a concrete look at the following:Stainless Steel Link Chain

In view of this knowledge, we understand that there are two main types of industrial conveyor failure: One is the failure caused by wear; We also learned that wear failure is the most common and most obvious form of expression. There are many reasons for this failure, the main reason is the poor quality of industrial conveyor chains and improper operation of workers. The most easily worn part of the chain is the sprocket and pin shaft.Stainless Steel Link Chain